Epoxy flooring in Moradabad

Moradabad is known worldwide for brass and metal handicrafts, and most of that work is for export. A typical export unit has several very different spaces under one roof: casting and polishing sections, electroplating or lacquering areas, finishing and quality control, packing halls and a showroom where foreign buyers see the samples. Epoxy flooring suits many of these spaces, but not all, and the difference matters.

Packing halls and export warehouses

Export packing is where floor dust causes real problems. Polished brass and lacquered pieces pick up dust, cartons get dirty, and buyers' inspectors notice. An epoxy coating or self levelling epoxy:

1. seals the concrete so it stops shedding dust
2. makes sweeping and mopping quick
3. gives a light-coloured surface where small parts and scratches are easy to spot
4. can be marked into packing, inspection and dispatch zones

Buyer showrooms

Showrooms where overseas buyers review samples should look professional. Self levelling epoxy in a neutral colour gives a clean, seamless floor that lets products stand out. A UV-stable topcoat keeps colours true near windows.

Finishing and QC areas

Finishing sections handle polishing compounds, lacquers and solvents. Epoxy resists these in normal use, and a smooth floor helps keep finished pieces clean. Areas with heavy solvent use may need a more solvent-resistant topcoat, which we check against the products you use.

Where standard epoxy isn't enough

Electroplating and pickling areas. Acids and plating solutions will attack standard epoxy. These areas need a chemical resistant floor, usually novolac epoxy or vinyl ester, with proper containment and drainage.

Casting and melting sections. Hot metal and heat damage resin floors. Floors near furnaces need heat-resistant concrete or refractory finishes.

Heavy polishing with water. Constant wet slurry areas may do better with a textured, more robust system.

Being clear about this saves money, because epoxy goes where it performs and specialist systems only where they're needed.

Planning a job in Moradabad

Moradabad is a few hours from our Roorkee base, so we plan to make each trip count:

• a site visit to see all sections, test moisture and measure
• a written, area-by-area recommendation
• installation timed around export deadlines and shipment dates
• phased work so packing and dispatch keep running

FAQs

Can epoxy be used in our electroplating section?

Not standard epoxy. Plating and pickling areas need a chemical resistant system.

Can the packing hall be done without delaying a shipment?

Yes, if we plan around your dispatch dates and work in zones.

Which colour is best for a handicraft packing hall?

Light grey or off-white, so dust and small parts are easy to see.

Call +91-8755475716 or fill in the form below to book a visit in Moradabad. More details are on our epoxy flooring page.